.jpg)
GET THINGS MOVING WITH THE DE-SHEETER DEVICE
The De-Sheeter Device removes deck or waste sheets from corrugated units. It allows operators to stand beside the unit to remove banding rather than standing on the conveyor. Once the product is positioned, the DSD grips and pulls the bottom sheet from the unit while keeping the unit square. After the de-sheeting, the product continues down the line without manual intervention.
SPECIFICATIONS:
Between Frame Dimensions | 28” (at funnel feed end of device) |
Diameter | 10’‑2 7/16” overall length |
Top‑of‑Roller Height | For 12” T.O.R. standard (heights over 12” available) |
Drive Capacity | 3,500 lb/unit |
Stripper Speeds | 90 FPM |
Gearmotor Rating | 1 HP flange mounted 1 3/8” hollow bore |
Air Requirement | 80 PSI |
CONSTRUCTION:
Frame | All‑welded steel construction. |
Drums | 6 5/8” Dia. x 96” Face x 1 1/2” Dia. shaft drive pulley3” Dia. x 96” Face x 1” Dia. idler pulley |
CONTROL OPTIONS:
Automatic | Positioning controls with electro‑mechanical sensor actuation |
Manual | Pushbutton operation |
CONFIGURATIONS:
Reversed Feed Configuration | 1. Chain Transfer Device delivers load to DSD line and edge justifies. 2. Load is reverse fed to DSD and deck, or waste sheet(s) are stripped from load bottom. 3. Load is conveyed back to Chain Transfer Device and is then transferred to machine infeed line. |
Direct Feed Configuration | 1. Edge justified load is fed directly into DSD. 2. Deck, or waste sheet(s) are stripped from load bottom. 3. Load is transferred with Chain Transfer Device to machine infeed line. |
